Logo

C3407 BMW Fault Code

Check C3407 OBD Fault Code Reason
Description:

Engine Coolant Temperature (ECT) Circuit High Input Indicates the sensor signal is greater than Self-Test maximum. The ECT sensor maximum is 4.6 volts or -50 C (-58 F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to power Damaged PCM Improper harness connection Damaged sensor ECT V PID reading greater than 4.6 volts with key ON and engine OFF or during any engine operating mode indicates a hard fault.

C3407 Code Symptoms :

See C3407 in engine

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C3407 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing C3407

C3407 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix C3407 code ?

See C3407 repair manual
  • Camshaft advance mechanism binding (VCT unit)
  • Camshaft Position Sensor harness is open or shorted
  • Faulty oil control valve (OCV)
  • Exhaust gas leaks

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.

BMW Cars that meet C3407 error